Bike Talk motorcycle forum

Do any of you know about a Dobecks TFI unit? Adjusting the TFI controller It's supposed to allow you to adjust fuel injection much like you would a carburetor. I'm not much good with computers and know nothing at all about power modules and maps so this looks like it might allow me to change the lean condition I think I'm experiencing. Any thoughts.

So... At Laconia Bike Week a HD dealer (which I wrote about in another thread, you know, the one just south of Laconia that cost a buddy almost two days repair on a harness) was offering FREE oil and filter changes! Four of us took advantage of this amazing offer just for bike week attendees. They did the changes while they made believe they were fixing the wiring issue. If ya wanted the synthetic oil you only paid $20. Pretty good deal huh?! Well I just came up from the garage and I'd like to send a letter boom to them.

First I took your suggestions and punched a hole in the oil filter to drain it first. Nice and neat SO FAR. I let it drain for over an hour. Then I took my HD filter wrench, the expensive machined aluminum one, and applied it and all it did was spin because the...

MY DAD IS A DANCER
One day a fourth-grade teacher asked the children what their fathers did for a living.
All the typical answers came up -- fireman, mechanic, businessman, salesman... and so forth.
However, little Justin was being uncharacteristically quiet, so when the teacher prodded him about his father, he replied,
"My father's an exotic dancer in a *** cabaret and takes off all his clothes to music in front of other men and they put money in his underwear. Sometimes, if the offer is really good, he will go home with some guy and stay with him all night for money."
The teacher, obviously shaken by this statement, hurriedly set the other children to work on some exercises and took little Justin aside to talk to him.
"Is that really true about your father?"
"No," the boy...

I had borrowed this from another site and copied it for future use, so here it is.

1. Remove ignition switch and the two screws holding the inner-fairing cap. Lifting the cap out of the way gives access to the fork top plug. I tried a 36mm socket but there wasn't room, same for a crescent, but the 36mm wrench in the tool kit was the solution. The plug is not on tight and removal is easy.

Note) the 36mm wrench is actually a bit too large and 1 3/8" is a better fit.

2. I used a ½" clear plastic tube cut to about 10" in length and inserted a small funnel on one end and stuck the other end into the fork top. It was a tight fit but worked. I wire-tied the funnel to the handlebars to keep it from slipping. Put a plastic bag on the tank to protect it from fluid that might spill out of the...

Hey guys, Is it possible to fill the forks on my Streeglide by just removing the swtch cosole and the fork bolts? Without removing the Whole inner fairing?